VMS.DevelopConfigForRun History

Hide minor edits - Show changes to markup - Cancel

September 10, 2012, at 05:38 AM by 24.130.186.152 -
Changed line 4 from:

Once a project has been cloned and setup in netbeans, the next step is to get the repository that holds the input files and scripts that may be needed. Directotions are on |this page

to:

Once a project has been cloned and setup in netbeans, the next step is to get the repository that holds the input files and scripts that may be needed. Directions are on the cloning 2__runs_and_data page

September 10, 2012, at 05:35 AM by 24.130.186.152 -
September 10, 2012, at 05:35 AM by 24.130.186.152 -
Changed line 4 from:

Once a project has been cloned and setup in netbeans, according to this page, the next step is to get the repository that holds the input files and scripts that may be needed. Directotions are on |this page

to:

Once a project has been cloned and setup in netbeans, the next step is to get the repository that holds the input files and scripts that may be needed. Directotions are on |this page

September 10, 2012, at 05:30 AM by 24.130.186.152 -
Changed lines 4-6 from:

Once a project has been cloned and setup in netbeans, according to this page, then in netbeans, right click on the project name, and choose the "run" bullet. Set the "run directory" to be the top directory of the 2__runs_and_data repository clone you made. Then set the "run command" to be

to:

Once a project has been cloned and setup in netbeans, according to this page, the next step is to get the repository that holds the input files and scripts that may be needed. Directotions are on |this page

Once the project compiles, and the 2__runs_and_data directory has been cloned, then in netbeans, right click on the project name, and choose the "run" bullet. Set the "run directory" to be the top directory of the 2__runs_and_data repository clone you made. Then set the "run command" to be

September 10, 2012, at 05:27 AM by 24.130.186.152 -
Changed line 4 from:

Once a project has been cloned and setup in netbeans, according to this page, then in netbeans, right click on the project name, and choose the "run" bullet. Set the "run directory" to be the top directory of the 2__runs_and_data repository clone you made. Then set the "run command" to be

to:

Once a project has been cloned and setup in netbeans, according to this page, then in netbeans, right click on the project name, and choose the "run" bullet. Set the "run directory" to be the top directory of the 2__runs_and_data repository clone you made. Then set the "run command" to be

Changed line 6 from:

The notes on the project will give the path to the project input file to use.

to:

The notes on the project will give the path to the project input file to use.

September 10, 2012, at 05:26 AM by 24.130.186.152 -
Added lines 1-6:

Configuring Netbeans to find input files for a Project

Once a project has been cloned and setup in netbeans, according to this page, then in netbeans, right click on the project name, and choose the "run" bullet. Set the "run directory" to be the top directory of the 2__runs_and_data repository clone you made. Then set the "run command" to be

 "${OUTPUT_PATH}" <some project-specific path to an input file>

The notes on the project will give the path to the project input file to use.